Kyocera Taskalfa Pro 15000c - Page 33

2-17
The main unit setup procedure > Remove the transportation spacers
[CONFIDENTIAL]
7
Re-install the cap unit [A] until feeling a click.
• Confirm if the center of the shaft [B] matches with center of position [C].
8
Remove the treatment front plate [A]. (Screw x2)
9
Remove the treatment rear plate [A]. (Screw x2)
IMPORTANT
If forgetting to remove the cap plate, C2100 will occur.
C2100: Treatment carriage HP sensor error (See page 5-1
for the corrective action of service call)
[A]
[B]
[C]
[A]
[A]