6-24
Machine transportation after setup > Procedure for the main unit transportation (Truck transportation)
[CONFIDENTIAL]
40
Tighten the screws on the bottom of the image conveying unit [A]. (Screw x4)
(The screw has a tag [B])
41
Push the image conveying unit [A] into the main unit and tighten it. (Screw x4)
• Make sure not to contact the [B] section of the treatment unit when inserting the conveying unit [A].
In case if it is difficult to reattach the screw, attach the screw [C] by sliding it to the aperture while slightly lifting
the front [A] or the rear [B] of the image conveying belt unit. (screw x4)
[C]
[C]
[C]
[C]
[A]
[B]
View after removing image conveying belt unit
* Screw sliding direction
To Next Page
Loading...
