6-47
Machine transportation after setup > Procedure for the main unit transportation (Truck transportation)
[CONFIDENTIAL]
49
Place 2 sheets of paper [B] on the image conveying belt and cover them with 2 sheets
of Kim towel that are folded along with long side.
• The paper have to be Ledger (In case of A3, fold at 30 to 40 mm from long edge) and put them on cut out [A]
of the cover.
• Kim towel has to be set as folded edge is outside and pile up at center.
50
Push the image conveying unit [A] into the main unit slowly.
• Make sure not to contact the [B] section of the treatment unit when inserting the conveying unit [A].
51
Pull paper [A] straight out and Kim towel [B] from the image conveying belt slowly.
• Pull them little bit and bring the Kim towel [B] to the center then remover them.
[A]
[C]
[B]
Ledger [B]
[C]
A3 [B]
To Next Page
Loading...
