2-42
The main unit setup procedure > Ink initial supply (Set up flow)
[CONFIDENTIAL]
16
Turn the power switch [A] off where is located at the front side of the main unit.
17
Attach the rear left upper cover [A] and turn the power switch on. (Screw x6)
Wait more than 5 seconds between the power off and on.
18
Enter maintenance mode.
19
Select [Cleaning] in U744 Head Cleaning and select [Normal] for each color then
press [Execute]/[Start] to perform purge.
The machine can be operated by the ink temperature of over 26 °C.
Once it is executed, it is not possible to cancel the operation.
In case of displayed temperature is below 26 °C, select the priority mode to "Printing" in U735 <Ink temperature
control setting>.
To Next Page
Loading...
