Kyocera Taskalfa Pro 15000c - Page 132

4-29
Troubleshooting > Troubleshooting When Printing Image
.
Settings Temperature U734 U736
Setting 1 Normal On
*1
*1 When U734 is set to [Off], configure the settings of U736 as below.
In case of temperature is normal or high:
U736 > Ink discharge > Job start and Specific Interval > Mode3 (400)
In case of temperature is low:
U736 > Ink discharge > Job start and Specific Interval > Mode5 (160)
Ink discharge: Off
Low Ink discharge > Specific Interval >
Mode3 (400)
High Ink discharge > Specific Interval >
Mode5 (1600)
Setting 2 Normal On
*1
Ink discharge > Specific Interval >
Mode5 (1600)
Low Ink discharge > Specific Interval >
Mode4 (800)
High Ink discharge > Specific Interval >
Mode4 (800)
Setting 3 Normal On
*1
Ink discharge > Job Start
Low
High
Setting 4
*2
*2 When Void area at the leading edge is observed, configure the settings of U736 as
below.
In case of temperature is normal or high:
U736 >Ink discharge > Job start and Specific Interval > Mode4 (800)
In case of temperature is low:
U736 >Ink discharge > Job start and Specific Interval > Mode3 (400)
Normal Off Ink discharge > Specific Interval >
Mode4 (800)
Low Ink discharge > Specific Interval >
Mode3 (400)
High Ink discharge > Specific Interval >
Mode4 (800)
Setting 5
*3
Normal Off Ink discharge > Specific Interval >
Mode3 (400)
Low On Ink discharge > Specific Interval >
Mode2 (160)
High On Ink discharge > Specific Interval >
Mode3 (400)
Setting 6
*4
Normal Off Ink discharge > Job Start and Specific
Interval > Mode2 (160)
Low
High