2-2
Daily Management and Maintenance > Before Using this Machine
Before Using this Machine
Before adjusting this machine, perform the following steps.
1
Print the maintenance report.
The maintenance report describes the current setting values of professional settings. If you
restore the settings after adjusting, refer to the maintenance report.
1 [Home] key > [...] > [Professional Settings] > [U000 Output Maintenance Report] >
[Maintenance] > select [On] > [Start] key > [Print] > [Start] key
Maintenance Report is printed.
2 Check the setting values of the professional settings in the maintenance report.
3 [Stop] key > [Close]
Professional settings close.
2
Perform the test print.
If there is no problem on printouts, start the normal printing (mass printing).
If there is any problem, go to step 3 to 4.
3
Take action properly shown below.
"Chapter 19 Troubleshooting" of Operation Guide
If the problem is not solved, refer to following.
4
Change the settings as necessary.
For how to adjust the color drift of the image, refer to the following
For how to change settings, refer to the following
Troubleshooting (page 4-1)
Improving and maintaining of print quality (page 2-3)
Changing Settings (page 2-17)
To Next Page
Loading...
