4-57
Troubleshooting > Troubleshooting When Discharging Paper
Punch position is misaligned
Remedy 1: Adjusting the back and forth difference of the punched hole
1
[Home] key > [...] > [Professional Settings] > [246 Adjust
Finisher] > [01 Finisher] > [01 Punch Resist]
2
Adjust the setting value using [+], [-] key and numeric keypad.
The range of the set value is as follows.
If the paper is conveyed obliquely (Sample 1), increase the setting value.
If the paper Z-folds (Sample 2), lower the setting value.
3
Press the [Start] key > [Stop] key.
Cause Corrective Actions
Reference
Page
The position of the punched
hole is misaligned forward or
backward with respect to the
end face of the paper (there is a
difference between front and
back).
Remedy 1: Adjust the back and forth
difference of the punched hole.
page 4-57
The stop timing of the position to
open the punch hole is not
correct.
Remedy 2: Adjust the stop timing of the
position to open the punch hole.
page 4-58
The center position of the
punched hole is misaligned.
Remedy 3: Adjust the positions of the
punched holes evenly from the center.
page 4-58
Holes were punched in the thick
paper.
Remedy 4: Add a correction value to
support thick paper.
page 4-59
Item Range Default Amount of change
01 Punch Resist -20 to 20 0 0.15 mm
To Next Page
Loading...
