2-7
Daily Management and Maintenance > Improving and maintaining of print quality
6
Measure the length from the leading edge of the chart to the
line of the image with a ruler.
7
Press [System Menu/Counter] or [Stop] key
8
Enter the value obtained by subtracting 20 from the value
measured in step 6 in [1st side] or [2nd side] using [+], [-] or the
numeric keys > [Start] key
The range of the set value is as follows.
9
[Stop] key > [Close]
[U034 Adjust Paper Timing Data] was configured.
Go to next step to adjust the center position of image sensor.
10
Load A4 or Letter size paper in cassette 1
11
[Home] key > [...] > [Professional Settings] > [U755 Adjust
Conveying CIS] > [01 Center Pos Adj] > [02 Print] > [Start] key
The front side chart is printed.
Item Range Default Amount of change
Start Position -3.00 to 3.00 - 0.1 mm
To Next Page
Loading...
