2-11
Daily Management and Maintenance > Improving and maintaining of print quality
10
Expand the chart and restore to the original position, measure
the difference between the center line of the chart image and
the crease with a ruler.
11
Confirm that the value (difference) measured in step 10 is 0.
If the center line is to the right or left of the crease, contact our service representative.
12
Press [System Menu/Counter] key or [Stop] key
[U034 Adjust Paper Timing Data] was configured.
Go to next step to adjust the side position of image sensor.
13
Load A4 or Letter size paper in cassette 1
14
[Home] key > [...] > [Professional Settings] > [U755 Adjust
Conveying CIS] > [02 Side Pos Adj] > [02 Print] > [Start] key
To Next Page
Loading...
