4-23
Basic Operation > Loading Originals
2
Place the originals.
1 Put the side to be scanned (or the first side of two-sided originals) face-up. Slide the
leading edge into the document processor as far as it will go. The original loaded indicator
lights when the original is placed correctly.
For details on Original Orientation, refer to the following:
Original Orientation (page 13-5)
• Confirm that the original width guides exactly fit the originals. If there is a gap,
readjust the original width guides. The gap may cause the originals to jam.
• Ensure that loaded originals do not exceed the level indicator. Exceeding the
maximum level may cause the originals to jam.
• Originals with punched holes or perforated lines should be placed in such a way
that the holes or perforations will be scanned last (not first).
To Next Page
Loading...
