6-11
Using Custom Paper > Setting from the Operation Panel
Adjusting the Print Position to Correct Image Drift
If the starting image print position is off, or the starting print positions on the front and back sides are not aligned in two-
sided printing, you can adjust the timing of the starting print position in the direction perpendicular to the paper
movement direction. This is referred to as "Starting Timing Adjustment".
If the center of the printed image does not match the center of the paper, you can move the printed image along the
paper movement direction to align the center of the image with the center of the paper. This is referred to as "Centering
Correction".
1
Display the screen.
[System Menu/Counter] key > [Device Settings] > [Paper Feeding] > "Cassette Settings"
[Cassette 1 (to 8) Settings] > [Manual]
2
"Adjustment Items" [Print Chart/Help] > [Print]
A test chart is printed.
3
Measure the correct value of front side.
1 Place the chart face printed as "FR" face up.
2 Valley fold the chart along the horizontal line at the top of the chart.
3 Read the scale "PT1" and find the value where the leading edge of the paper and the
starting timing overlap.
In the example below, the line above -4 overlaps the leading edge of the paper, so "-3" is
the correction value.
To Next Page
Loading...
