Kyocera Taskalfa Pro 15000c - Precautions for Outputting Paper; Finishing Large Size Paper from Right Tray; Finishing Paper in High Density from Right Tray

8-9
Finishing Paper > Precautions for Outputting Paper
Precautions for Outputting Paper
Finishing Large Size Paper from Right Tray
To output large paper of A3 or greater size from the Right Tray, open the tray as shown.
Finishing Paper in High Density from Right Tray
If you print on large paper at a high print density, the paper may bow. You can avoid bowing by changing the angle of the
Right Tray.
1
Loosen and remove the screws (x2) on the rear side of the
Right Tray with your fingers.
IMPORTANT
When outputting paper with a low moisture content or plain paper with high density printing, the output may
push away other output due to curling, and the print order may become inconsistent. Adjust using main unit
decurl adjustment, or use heavy paper or paper with a high moisture content to avoid this problem.
Reducing Paper Curl When Outputting to the Right Tray (page 6-5)