11-3
Scanning > Sending Document via E-mail
Sending Document via E-mail
Configuring Settings before Sending
Before sending an E-mail, configure the SMTP and E-mail settings using the Command Center RX.
E-mail Settings (page 3-51)
Sending Scanned Document via E-mail
1
[Home] key > [Send]
2
Place the originals.
3
In the basic screen for sending, select [+] > [Email]
4
Enter destination E-mail address > [OK]
Up to 256 characters can be entered.
To enter multiple destinations, select [Next Destination] and enter the next destination. Up to
100 E-mail addresses can be specified.
You can register the entered E-mail address in the Address Book by selecting [
Add to Address
Book
]. You can also replace the information for a previously registered destination.
Destinations can be changed later.
5
Select the functions.
Select the Global Navigation to display other functions.
6
Press the [Start] key.
Sending starts.
Handling Destination (page 4-15)
Character Entry Method (page 4-8)
Checking and Editing Destinations (page 4-18)
Send (page 11-4)
To Next Page
Loading...
