Kyocera Taskalfa Pro 15000c - Sending Document to Folder on an FTP Server (Scan to FTP); Configuring Settings before Sending; Sending Document to Folder on an FTP Server

11-9
Scanning > Sending Document to Folder on an FTP Server (Scan to FTP)
Sending Document to Folder on an FTP
Server (Scan to FTP)
Configuring Settings before Sending
Before sending a document, configure the FTP Client (Transmission).
Protocol Settings (page 15-50)
Sending Document to Folder on an FTP Server
1
[Home] key > [Send]
2
Place the originals.
3
In the basic screen for sending, select [+] > [FTP]
4
Enter the destination information.
Character Entry Method (page 4-8)
The table below lists the items to be set.
Handling Destination (page 4-15)
Item Descriptions
Host Name Host name or IP address of FTP server
You can also specify the port number. Enter the following format
separated by a colon.
"Host name: port number" or "IP address: port number"
To enter the IPv6 address, enclose the address in brackets [ ].
(Example: [2001:db8:a0b:12f0::10]:21)
If the port number is not specified in [Host Name], the default port
number is 21.
Port Port number
If the port number is not specified, the default port number is 21.