15-50
Setting up from System Menu > Network Settings
Others
Protocol Settings
[System Menu/Counter] key > [Network Settings] > "Network Settings" [Protocol Settings]
Configure protocol settings.
Item Description
LAN Interface Specify the settings for the LAN interface to be used.
Value:
Auto, 10BASE-T Half, 10BASE-T Full, 100BASE-TX Half, 100BASE-TX Full,
1000BASE-T
After changing the setting, restart the network or turn the machine OFF and then ON.
Item Description
SMTP (Email TX) SMTP (Email TX) (page 15-39)
POP3 (Email RX) POP3 (page 15-39)
FTP Client (Transmission) FTP Settings (page 15-39)
FTP Server
(Reception)
Protocol
Settings
Select whether to receive documents using FTP.
The setting will be changed after restarting the device or network.
Value: Off, On
SMB Client (Transmission) SMB Settings (page 15-39)
NetBEUI Protocol
Settings
Selects whether to receive documents using NetBEUI.
The setting will be changed after restarting the device or network.
Value: Off, On
WSD Scan WSD Scan (page 15-40)
WSD Print WSD Print (page 15-40)
LPD Protocol
Settings
Selects whether to receive documents using LPD.
The setting will be changed after restarting the device or network.
Value: Off, On
Raw Protocol
Settings
Select whether to receive documents using Raw Port.
The setting will be changed after restarting the device or network.
Value: Off, On
IPP Protocol
Settings
Selects whether to receive documents using IPP. To use the IPP protocol, set
[IPP] to [On], and set [SSL] to [Off]. In addition, select [Not Secure
(IPP&IPPS)] on IPP Security under Security Settings from the Command
Center RX. The default port number is 631.
The setting will be changed after restarting the device or network.
Value: Off, On
To Next Page
Loading...
