Kyocera Triumph-Adler P-4025w - Cancelling Transmission (Disconnection of Communication)

3-6
Sending Faxes > Basic transmission procedure
Cancelling Transmission (Disconnection of Communication)
Follow this procedure to break the connection and stop transmission/reception.
1
Select the [Status/Job Cancel] key.
2
Disconnection of communication.
1 [FAX] > [OK] key
2 Check the status of communication.
3 Select [Line Off].
When communication is disconnected, transmission stops.
To cancel direct transmission, refer to the following:
To cancel a delayed transmission or send a fax by immediate transmission, refer to the following:
To cancel polling transmission, refer to the following:
NOTE
To cancel direct transmission, delayed transmission, or polling transmission, refer to the
section for that function.
Cancelling Direct Transmission (page 3-20)
Cancelling Delayed Transmissions (Queued) (page 3-20)
Polling Reception (page 5-19)