Kyocera Triumph-Adler P-4025w - FAX TX Report; Density; Duplex (Only on Models with a Duplex Scanning Function.)

3-21
Sending Faxes > FAX TX Report
FAX TX Report
You can check whether FAX was transmitted properly by printing the report after transmission.
Density
Adjust density.
(Value: [-4] to [+4] (Lighter to Darker))
Duplex (Only on models with a duplex scanning function.)
Select the type and orientation of the binding based on the original.
Item Description
Off Does not print reports.
On Prints reports.
Error Only Prints reports only if an error occurs.
NOTE
This setting is displayed if FAX TX Result Reports is set to [Specify Each Job].
Send Result Reports (page 7-4)
Item Value Description
1-sided ― Disables the function.
2-sided ― Select the [OK] key to scan the original with the default setting.
For the default settings, refer to the following:
Machine’s Operation Guide
Orig. Binding Left/Right, Top Select [Detail] to display the [Orig. Binding] screen.
Select the binding direction of originals, and select the [OK]
key.
Orig. Orientation Top Edge Top, Top Edge Left Select the orientation of the original document top edge to
scan correct direction, and select the [OK] key.