KYORITSU KEW 6310 - Wiring Check; Checking Procedure

5.3.1 Checking procedure KEW6310
5.7 KEW6310
5.3 Wiring check
Proper wirings can be checked at WAVE Range.
5.3.1 Checking procedure
1 Select the WAVE Range with Key and press the F2 Key.
2 Wiring check routine starts.
3 Wiring check complets.
OK is indicated if the connection is appropriate, and NG is displayed if the connection is improper.
Correct vector (varies depending
on wiring configurations)
Status is indicated when checking
starts.
NG parameters are displayed with
flashing.