KEW6310 13.2 USB driver installation
KEW6310 13.4
13.2 USB driver installation
(1) Connect one end of a USB cord to your PC.
(2) Connect the other end of USB cord to the instrument.
(3) When your PC and the instrument are connected properly, install starts.
(4) Click “Install the software automatically (recommended)”, and insert the “KEW PQA MASTER”
in your PC's CD-ROM drive. Then Click “Next”.
* When a device driver is not found automatically, click “kew_power.inf” of KEW PQA MASTER, which
Is in the CD-ROM drive.
To Next Page
Loading...
