KYORITSU KEW 6310 - Error Message; Section 15 Troubleshooting·············································································································

3.4.2 Error message KEW6310
3.13 KEW6310
3.4.2 Error message
Following screen may appear after a self-check routine.
● When a failure is detected;
This instrument automatically checks the internal circuit immediately after it is powered on.
If a suspect failure in the internal circuit is detected, the error screen below will be displayed for about 5 sec.
In this case, refrain from using the instrument and refer to “Section15: Troubleshooting” in this manual.
CAUTION
Notwithstanding the error screen, the measurement screen will appear and the instrument will take
measurements anyway. However, accurate readings may not be obtained.
● When connected sensors are changed;
Clamp sensors connected are displayed for 5 sec as follows. When no sensor is connected, previous
settings are kept.