KYORITSU KEW 6310 - Settings; Basic Setting

4.2.1 Basic Setting KEW6310
4.3 KEW6310
0
0
4.2 Settings
4.2.1 Basic Setting
Wiring Configuration
① 1P2W×1 Single-phase 2-wire (1ch) ⑩ 3P3W×1+2A
Three-phase 3-wire (1ch) +
2-current
② 1P2W×2 Single-phase 2-wire (2ch) ⑪ 3P3W3A Three-phase 3-wire 3A
③ 1P2W×3 Single-phase 2-wire (3ch) ⑫ 3P4W×1 Three-phase 4-wire (1ch)
④ 1P2W×4 Single-phase 2-wire (4ch) ⑬ 3P4W×1+1A
Three-phase 4-wire (1ch) +
1-current
⑤ 1P3W×1 Single-phase 3-wire (1ch)
⑥ 1P3W×2 Single-phase 3-wire (2ch)
⑦ 1P3W×1+2A
Single-phase 3-wire (1ch) +
2-current
⑧ 3P3W×1 Three-phase 3-wire (1ch)
⑨ 3P3W×2 Three-phase 3-wire (2ch) 4A 4-current
* Default value (or after system reset) : ⑬ 3P4W×1+1A
* Wiring of 4A can be selected only at W Range. Default value is adopted when selecting the other Ranges.
1 Press the Cursor Keys and select [Wiring], and then press the ENTER Key.
2 Press the Cursor Keys and select a proper wiring configuration, and then press
the ENTER Key.
List of wiring
configuration appears.
Selected wiring configuration is displayed.