8
3. Then connect the hotbed heating wire and thermistor wire, like in picture 3.
4. Install two-foot levelling pats as shown in picture 4, and adjust the height of the
foot levelling pats to make the printer stable or to the height that you need.
5. As shown in picture 5, fix the filament holder on the top profile, then tighten the
T-rod nuts of the holder.
Install the tempered Glass platform and Connect the power Cord
1. As shown in picture 1a and picture 1b, place the glass on the silver-white
platform and clamp it with the binder clips. Be careful not to clamp the hotbed
cable.
To Next Page
Loading...