PROGRAM MODE
Programming Note: If 30 seconds is allowed to pass, or the CH button is pressed
during the programming mode, the unit will confirm/set the last information
entered—the display will stop flashing and return to normal time-date readings. If
you don’t leave the program mode during the programming of sections IV through
XI, you can advance to step 4 of the next program setting. If you do leave the
program setting (or want to program a specific setting) follow each instructional
step to program that setting.
I. PROGRAMMING SEQUENCE AND DEFAULT SETTINGS
The programming sequence and default (factory) settings are as follows:
LCD Contrast 5
Time Zone -5 (Eastern)
Daylight Saving Time 1 (on)
Radio-controlled time reception ON
12/24-hour time 12
Time 12:00
Year 2003
Day and Month 1.1.
Snooze (this function not used) 10
Temperature Format °F
Forecast Sensitivity 2
Please note that while there is a snooze adjustment in the programming this is an
unused function as there is no alarm on the indoor weather station.
II. FUNCTION KEYS
The function keys are located on the front of the unit directly below the LCD.
III. SETTING THE LCD CONTRAST
1. Press and hold the SET button for 5 seconds.
2. “LCD” will show in the time LCD and the number setting will flash.
Note: There are 8 LCD contrast levels to choose from—“Lcd 0” is the
lightest, and “Lcd 7” is the darkest.
3. Press and release the IN button to select the level you desire.
6
To Next Page
Loading...
Need help?
General
