Customer Careline: 08457 573 479
Local rate UK number, Monday to Friday 9am-5pm
Website: www.labgear.co.uk
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority for
recycling advice.
© Philex Electronic Ltd. 2014. v3.2
The PSM114 is not waterproof and is intended for indoor use only and must not be xed where it could be exposed to
dripping or splashing water. Objects containing liquids should not be placed on or near the appliances.
To prevent the risk of re, objects with naked ames (such as lighted candles) must not be placed on or near appliances.
Fitted Mains plug
This appliance is supplied with a standard fused plug already tted. If this is not suitable, refer to the instructions below.
In the unlikely event that you need to change the fuse in the plug, a 3 Amp fuse to BS1362 carrying the ASTA or BSI
approval mark must be used. Always re-t the plastic fuse carrier when replacing the fuse.
Changing the Plug
If the mains plug is not suitable for the sockets in your home, it should be cut o and an appropriate new plug tted.
Wiring the new plug: Any instructions supplied with the new plug should be followed (these may state how much
insulation to remove from the wires in the mains cord). The Brown wire must be tted to the live + (L) terminal of the
plug and the Blue wire to the neutral - (N) terminal. Neither wire should be connected to the earth (E) terminal of the
3-pin plug (this appliance does not require an earth connection). Ensure that the cord grip is the plug is a fused type;
the fuse tted should be rated at no more than 3 Amp.
Caution: The old plug should be safely disposed of promptly since it could be dangerous if plugged into a live socket.
2 - Year Guarantee
Your amplier is guaranteed against faulty components or poor workmanship for
a period of two years from the date of purchase.
This guarantee does not cover accidental or malicious damage (Including damage from
natural causes such as lightning) and will be invalidated by installation or use other
than in accordance with these instructions, repair or attempted repair other than by the
manufacturer, or open or removal of the case. This does aect your statutory rights.
Labgear reserve the right to modify their designs or specications, In the light of future
developments, without prior notice. Performance gures quoted are typical and subject
to normal manufacturing and service tolerances
Technical Data PSM114E/S
DC output: 12VDC - Voltage tolerance 5% - Current 100mA
Connector type: Type-F (female) IEC60169-24
Signal frequency range: 44…862MHz
Signal insertion loss: 0.5dB
Power requirement under load: 230V~50Hz at <3W
Power requirement under no load: 230V~50Hz at <0.3W
Power indicator: Green LED
Operating Temperature: 0…40ºC
Dimensions: 44(H) x 68(W) x 88 (D) mm
Installation Instructions
ErP Compliant Power Supply
General Safety Precautions
To Next Page
Loading...