Page 32 of 43 – US –
Use:
Turn on main gas supply to range.
- Depress handle & rotate burner valve handle anti-clockwise past the
“IGN” position.
- Depress handle fully and wait for the burner’s thermocouple to heat
up. Hold for 15-20 seconds after flame has lit. Igniters will spark (click)
while handle is pressed.
- Release handle and rotate burner valve handle to “HIGH” position.
- Depress & rotate burner valve handle to the “LOW” position.
- To rotate burner valve handle to the “OFF” position, slightly depress
handle then move to the “OFF” position.
A reduced flow rate position identified by the “Low” mark produces
the preset minimum burner power. This setting is adjustable behind
the knob.
Useful hint:
Always choose a burner that matches the diameter of the utensil used.
Cleaning:
The burners are made in two parts in order to facilitate cleaning. Clean them separately.
After removing the pan supports and burners, the cooking surface can be cleaned easily and thoroughly by simply
using a sponge.
Do not use scouring pads or abrasive products such as oven cleaners and stain removers.
When cleaning, be careful not to splash liquid into the openings of the burners.
CAUTION:
During use of the cooking surface or
oven, accessible parts may become
very hot during use. Warn users of
the potential hazards.
To Next Page
Loading...
