Page 34 of 43 – US –
Use:
The traditional heating plate is coated with a black enamel coating. No maintenance or pre-treatment is necessary.
Not a direct cooking surface.
Turn on main gas supply to range.
- Depress handle & rotate burner valve handle anti-clockwise past the
“IGN” position.
- Depress handle fully and wait for the burner’s thermocouple to heat
up. Hold for 15-20 seconds after flame has lit. Igniters will spark
(click) while handle is pressed.
- Release handle and rotate burner valve handle to “HIGH” position.
- Depress & rotate burner valve handle to the “LOW” position.
- To rotate burner valve handle to the “OFF” position, slightly depress
handle then move to the “OFF” position.
A reduced flow rate position identified by the “Low” mark produces
the preset minimum burner power. This setting is adjustable behind
the knob.
Cleaning the heating plate:
Immediately remove any spillages to make cleaning easier. You can use commercially available special products for
cleaning cast iron.
If the cast iron is heavily soiled, use scouring pads and grease after cleaning.
To Next Page
Loading...
