LaCimbali Q10 New Touch - Mixer Cleaning

WASHING THE SOLUBLES CIRCUIT
The following indications are in addition to the washing
procedure described above.
MIXER CLEANING
1 powder funnel
2 powder storage drawer
3 mixer conveyor
4 mixer blade
5 nozzle
Here are the steps to perform at the end of the work day.
Please follow these steps:
1) Open the lock (A) to access the solubles mixer;
2) Open the control panel (B);
3) Detach the powder funnel (1);
4) Remove the nozzle (5) from the mixer conveyor (3);
5) Turn the ringnut (G) clockwise;
6) Remove the mixer conveyor (3);
7) Remove the mixer blade (4);
8*) Remove the powder storage drawer (2); the drawer (2)
can be cleaned weekly;
9) Use a brush to clean all the holes where the liquid passes
through.
Place ½ liter of cold water into a container and add a dose
of liquid detergent (see product instructions).
Wash the separte parts, removing any organic residue
with a sponge.
Immerse all mixer parts in the solution (water – detergent)
for at least 15 minutes.
Remove all parts from the solution and rinse.
10) Reassemble the parts and attach the mixer to its base.
Note: Take care when reattaching the mixer blade (4)
to the pin (P), and make sure the two flat parts on the 2
components match.
11) After the machine has returned to its normal working
conditions, perform a washing cycle following the
instructions described previously.
1 2
3 4
5 6
7
9
A
8*
B
1
3
5
3
G
4
10
2
4
P
1
3
4
2
5
68
English