Need help?Do you have a question about the Lafayette Ares and is the answer not in the manual?
General| Brand | Lafayette |
|---|---|
| Model | Ares |
| Category | Transceiver |
| Language | English |
Crucial safety advice, including not transmitting without an antenna and avoiding internal tampering.
Connect the antenna cable using a PL-259 connector and a 50 Ohm shielded cable for 27MHz.
Install the microphone bracket in a safe, non-interfering position within the vehicle.
Modern vehicles typically do not cause interference issues for the transceiver.
Connect the power cord's red wire to +13.8V and the black wire to the battery ground.
Overview of the transceiver's controls: microphone jack, power, squelch, display, selectors, and scan.
Step-by-step guide for connecting and operating the transceiver for the first time.
Detailed functions of the Power/Volume, Squelch, and AM/FM selector controls.
Description of the scanning feature to automatically search for active channels.
Use for emergency channel 9 access or to reset the radio to its initial conditions.
How to use the UP and DOWN buttons to select channels rapidly.
Details on the transmitter, receiver, voltage, temperature range, and channel step.
Output power, frequency range, tolerance, and modulation capabilities.
Sensitivity, squelch limit, S/N ratio, distortion, and maximum power.
Parameters used for testing: power source, ant load impedance, and audio load impedance.
Information regarding waste disposal of electrical and electronic equipment (WEEE) according to Italian law.
Guidance on end-of-life product collection for recycling and proper disposal of electronic waste.
To Next Page
