Need help?Do you have a question about the Lafayette LR-9090 and is the answer not in the manual?
General| Frequency response | 20Hz to 20kHz |
|---|---|
| Total harmonic distortion | 0.3% |
| Input sensitivity | 2.5mV (MM), 150mV (line) |
| Dimensions | 17.5 x 5.5 x 13.5 inches |
| Weight | 25 lbs |
| Signal to noise ratio | 90dB (line) |
| Speaker load impedance | 4-16 ohms |
| Signal-to-Noise Ratio | 90dB (line) |
How to connect the receiver to power and use convenience outlets.
Guidance on establishing a ground connection for system components.
Details on using the built-in ferrite loopstick and external wire.
Instructions for connecting 300-ohm and 75-ohm FM antennas.
How to connect speaker sets and understand impedance requirements.
Connecting headphones and record players to designated inputs.
How to connect single or multiple tape recorders for recording and playback.
Explanation of selector, monitor, and dubbing switches.
How to adjust tone, volume, balance, loudness, and mode settings.
Usage of filters, muting, and tuning controls.
Explanation of meters, muting switch, and phono sensitivity adjustment.
Steps for initial setup, powering on, and tuning FM stereo.
Techniques for noise reduction and optimizing phono input.
Procedures for recording, playing back, and copying tapes with recorders.
Connecting and operating an 8-track player and microphones.
Explains how turnover switches affect bass and treble control ranges.
Details on the receiver's circuit to prevent damage from overload.
Steps to identify and resolve common issues with the system.
Instructions for sending the unit for repair or warranty service.
To Next Page
