Automatic mode
By selecting the automatic mode, the electronic board
will automatically identify the most suitable power
supply in the following priority order: 230 V, 12 V, gas.
In passing from 12 V to gas, the automatic system
requires a waiting period of 15 minutes. This is to
prevent the fridge from passing too quickly to the gas
supply, when this is not necessary (for example, when a
short stop is needed at a fuel station).
Manual selection of the type of power supply
Gas supply is strictly forbidden during stops at filling
stations and when driving the vehicle. For safety
reasons, the gas supply can only be selected after 15
minutes have elapsed from the time the engine is
turned off. Concerning 12 V or 230 V power supply, if
these are selected respectively when the engine is off or
without connection to the external power grid, the
refrigerator does not operate. For these reasons we
recommend the automatic mode, which enables proper
and safe operation of the equipment.
11 - REFRIGERATOR
USER’S GUIDE
63
Refer to the manufacturer’s handbook for further
information on the refrigerator.
NOTE
• Use the utmost care in storing perishable food.
• If possible, the refrigerator should be turned on
for about 6 hours prior to inserting the food items.
• When parked, level the vehicle as much as
possible.
• Defrost when the ice thickness exceeds 3 mm.
• Wash the inside with suitable cleaners when the
appliance is no longer in use.
• Treat the rubber door seals with talcum powder.
• Insert the door safety device while travelling.
THINGS TO DO
• Do not open the door too often in summer.
• Do not introduce hot food.
• Do not consume perishable foods in case of
prolonged refrigeration interruption.
• Do not expose to the sun the wall where the
refrigerator is housed
• Do not damage or obstruct the air intakes.
• Do not leave the refrigerator doors closed during
a long period of inactivity.
• Do not dismantle the refrigerator on your own.
THINGS TO AVOID
To Next Page
Loading...
