Lakemaster M-1 - Page 10

damaged.
5
The hook or hopper fails.
The electromagnet is
damaged.
Repair or replace it.
The motor is
damaged.
Repair or replace it.
The control panel is
damaged.
Repair or replace it.
6
The indicator lights of
boat fail.
The plug to control
panel is not well
connected.
Re-connect it.
The LED is damaged.
Repair or replace it.
The FPC is damaged.
Repair or replace it.
The control panel is
damaged.
Repair or replace it.
7
The bait boat can’t move
forward.
The control panel is
damaged.
Repair or replace it.
8
Off tracking when the
boat goes left or right.
One of the motor is
wrapped by grass or
fishing line.
Remove the grass or fishing
line.
Different motor
speed.
Use the right lever to control
the speed.
9
Hopper’s load capacity
lowers or automatically
opens after full-load.
The magnet is
covered by dirt.
Clear the dirt.
Demagnetization.
Replace the magnet.
The control panel is
damaged.
Repair or replace it.
10
The boat leaks.
The sealing strips or
sealant fail.
Replace the strips or sealant.
The boat is aging or
has collided.
Seal with sealant or change
the main body.
11
The motor leaks.
The oil seal is aging or
damaged.
Replace the oil seal.
12
Too much noise when
the motors work.
The motor is
damaged.
Repair or replace it.
The motor is
wrapped by sundries.
Clean the motor.