27
CLEANING AND PREVENTIVE
MAINTENANCE
PRECAUTION AND CLEANING
INSTRUCTIONS
- IMPORTANT : Before carrying out the
cleaning and maintenance operations,
disconnect the equipment from the mains
power supply:
- Follow the directions on the maitenance in
this guide;
- Wear protective clothing and gloves when
challenged elements are impregned with
clearing solution;
- High temperatures can be reached inside
the machine (90°C). After power supply has been
removed, wait until the machine has reached
room temperature, before working on it.
- Never leave tools, parts or other loose
material in or on the machine;
- Chek that there are no rusting foreign
bodies, because of the material “stainless steel”
could begin to rust. Rust particles can come from
non- stainless steel dishes or damaged wire
baskets.
- Do not wash the machine and the area
surrounding it with fire hydrants, steam jets of
high-pressure cleaners;
- When clearing the floor be careful not to
saturate the base of the machine, in order to
avoid a prolonged stagnation of water;
- To clean the inside of the machine, use a
brush or a soft cloth;
- To clean the machine do not use abrasive
cleaners;
- BEFORE starting machine or cycle, after
any maintenance or repair work, make sure
all protectives are correctly installed;
DAILY CLEANING OF THE INTERIOR
OF THE DISHWASHER
- Disconnect the machine by pressing the main
switch "A";
- Remove the overflow pipe and let the
water drain out of the tank (look at the
specific paragraph at the preceding page);
- Wait untill all water is drained and there are no
wastes on the tank bottom;
Once the emptying is completed, indicator “C”
will automatically turn off after about
15”seconds
- Disconnect the machine from the supply mains
by the wall switch;
- Take the filters out and clean them under
running water;
- Re-assemble the removed parts in their
housing;
- Check and clean the washing and the rinsing
jets;
- Clean the outer surface of the machine by
using a wet sponge; do not use water jets
because, besides being dangerous, they could
damage the electrical parts; do not use
abrasive detergents;
- When the machine is to remain unused for a
long time, it’s better to perform the operation
od descaling and sanification.
- To avoid bad smells, leave the hood open.
Attention. Before carrying out cleaning
the inside of the machine, make sure that there
are no foreign objects that could damage the
rusty steel inside the tank. The eventual rust
particles could come from non-stainless steel
dishes, from baskets or damaged water pipes
not rust-proof.
NEVER WASH THE EXTERNAL PART OF
THE MACHINE WITH A WATER JET
To Next Page
Loading...
Need help?
General
