How to disable-enable the SOFT-START
By default the machine is provided with MANUAL start by cycle pushbutton ‘C’.
It’s possible to set (enable) the AUTOMATIC start of the cycle at the door closing by following the
instructions below:
1. Close the door of the machine;
2. Turn the machine off by pressing the wall switch,
3. Press the Wash time selection pushbutton ‘B’,
4. Always keeping pressed the pushbutton ‘B’, turn the machine on by pressing the wall switch,
5. Keep the pushbutton ‘B’ pressed for 3 seconds,
6. Release the pushbutton and turn the machine off by pressing the wall switch.
To enable again the MANUAL start function, follow the same steps.
To Next Page
Loading...
Need help?
General
