110
6 Operating Control and Displays
In case of arising problems (incorrect terminating resistor, etc.) the following error message is
displayed:
Fig. 6-14 Error message ’No device identified’
6.3.1.5 Release Codes/Release Levels
After completing the installation the software starts in ’DEMO’ mode. The range of functions is
restricted. For instance, connections to target devices are impossible.
• In order to run the software with a broader range of functions, enter the activation key first.
This key is provided by LAMTEC in combination with an USB-CAN module.
NOTICE
The activation key applies exclusively to one particular USB-CAN module in each case. To en-
ter the key this USB-CAN module has to be connected already.
• Access to the input mask for this activation key is available either by menu (Options >>
Enter unlock code) or by clicking the ’Key’ icon. The process involving the Key icon is de-
scribed here:
To Next Page
Loading...
