121
6 Operating Control and Displays
1 Fault selection tab
2 Description of fault
3 Time that fault occurred (estimated)
4 Burner status display
NOTICE
The date and time of the fault are calculated basing on the operating hours accumulated at
the time of the fault, the current BurnerTronic operating hours, and the computer time. If
BT300 was disconnected from the mains after fault occurred and before fault has been read,
the date and time of the fault will not be calculated correctly.
Call more fault histories by CO/O
2
fault histories and temperature statistics.
Fig. 6-31 Fault information
To Next Page
Loading...
