133
6 Operating Control and Displays
Fig. 6-46 Programming of firing rate curve
NOTICE
You do not need to adjust all provided curve points on the firing rate curve. The BT300 inter-
polates between two adjacent curve points linearly, regardless curve points in between are
plausible or not.
Changing curve point
1. Use buttons and to choose firing-rate point on firing-rate axis.
2. Click on the modifying channel.
3. Use buttons and to change position of the actuator.
4. Save curve point to complete changes (button ’point stored’).
The curve point is changed.
6.3.6 Programming a Staged Operation
NOTICE
Up to v3.6, the coarse setting of all existing firing stages must be carried out in cold setting!
As of v3.7, this setting can also be carried out in control mode.
To Next Page
Loading...
