134
6 Operating Control and Displays
6.3.6.1 Setting the Stage Operation up to v3.6
1. Click in menu on ’Curves (Fuel/Air ratio control)’
Fig. 6-47 Curve selection
Window ’Curves (Fuel/Air ratio control)’ opens.
Fig. 6-48 Curves window
2. Click button ’Start EI-Mode (Setting)’.
3. Quit the message ’Start setting’ with OK.
NOTICE
Click button OK in the message during running time of the blue bar. Without any action in the
meantime the process will be aborted and an error message is indicated.
You are now in ’Setting’ mode. This is indicated by wrench icon and red frame around the
dialogue.
To Next Page
Loading...
