158
7 Maintenance
7.2 Firmware Update BT300
NOTICE
Firmware Updates can only be processed with LSB Remote Software version OEM-Level and
higher.
NOTICE
To switch OFF the burner before starting the firmware update via LAMTEC SYSTEM BUS is
mandatory!
NOTICE
Only one device of the same type as the one you want to update may be connected to
LAMTEC SYSTEM BUS (p. ex. LCM100). This device must be integrated in LSB family 1.
NOTICE
Check the safety functions after every update!
Firmware Update
Release Level 2 necessary
1. Connect LAMTEC SYSTEM BUS to your computer and start the LSB Remote Software.
2. Establish online connection.
3. Store dataset.
4. Disconnect online connection.
5. Select Flash Tool.
Fig. 7-2 Device information - customer ID
To Next Page
Loading...
