249
11 Appendix
Hint 39:
Main processor does not reach ignition position
Hint 40:
Monitoring processor does not reach ignition position
Hint 41:
Main processor is not in pre-purge position
Hint 42:
Monitoring processo is not in pre-purge position
Hint 955:
Purging is activated permanently (symbol is flashing).
Hint 1086:
Maintenance of the burner is necessary.
Hint 2001:
The time running between the signal ’Valve is open’ and the signal ’Flame’ is relatively long.
Hint 2002:
Dynamic test of the electronic ratio control is running.
Hint 2003:
The factory settings with a standard curve are active. The burner cannot be started.
UI300: Enter password for access level 1.
LSB remote software: Delete curve and programme new curve.
Hint 2004:
Data are set back to standard.
Hint 2005:
The automatic restart has failed.
Hint 2006:
Communication between LSB Remote Software and BT300 is interrupted while LSB Remote Soft-
ware was in SETTING mode.
Hint 2007:
While saving a firing rate point in an active O
2
curve, writing of an O
2
value was not possible.
Hint 2008:
CPI mode is not possible.
Hint 2009:
Temperature limit and timer are causing a recirculation delay.
Hint 2101:
SETTING mode is not possible. Insufficient access rights!.
Hint 2010:
The minimum burner-OFF time has not yet elapsed.
Hint 2011:
The influence on the CO/O
2
controller is zero.
To Next Page
Loading...
