250
11 Appendix
11.2 Indication Symbols
Hinweis 2012:
Start load limitation is active
Hinweis 2013:
Recirculation correction configuration incorrect
Hinweis 2014:
Post-purge ventilation after ongoing safety shutdown
Hinweis 2015:
Fault reset delayed because post-purge ventilation is in progress after safety shutdown
Hinweis 2016:
Fuel pressure missing
Back to previous window.
With the cursor keys, you can navigate around the menü.
With the cursor "to left" and "to right", you can move gradually in the selected line.
At the end of the selected line, the cursor would jump to the next line below if it exists.
In multiline menüs, you can switch within the lines with the keys "upwards" and "downwards".
In the parameter display, you can switch between the individual fields.
With the Enter key, you can call up the menü in the startup screen. In a menü window, open the
selected submenü. In a parameter window, you can transfer the adjusted values by the Enter key.
Under the INFO path, you can obtain information regarding:
• Burner
•Fault
• Software version
• Display of the check sums
• Serial number
• Servomotor position (current flap position per channel)
• Digital input/output
Under the SETTINGS path, you can obtain and set information regarding:
•Password
• Settings of the burner (display and settings)
• Actuator settings (display)
• Air/fuel control
• Delete curve
• Settings of the display
To Next Page
Loading...
