EasyManua.ls Logo

LANBO LW80SEU - Page 5

Default Icon
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
or separate remote-control system.
• WARNING: Keep all ventilation openings in the appliance enclosure clear of
obstruction.
• WARNING: Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the manufacturer.
• WARNING: Do not damage the refrigerant circuit.
• Allow at least 10 cm spacing around the appliance for ventilation purpose
during use.
• Do not use a water jet, flush directly with water or steam cleaner as the parts
will get wet and electric shock might be resulted.
• CAUTION! Securely route the power cord if necessary in order to prevent
unintentional pulling or contact with the heating surface.
• Do not clean or store the appliance unless it is completely cooled down.
• The appliance should not be tipped over an angle of 5°. After installing the
appliance, wait for 2 hours before connecting it to the electrical power supply to
switch on. The same applies if the appliance is moved at a later date.
Intended use
• This appliance is intended for buffet and household use.
• The appliance is designed only for wine storage and cooling. (e.g.
Champagne, white wine, red wine, etc.). Any other use may lead to damage to
the appliance or personal injury.
• Operating the appliance for any other purpose may deemed as a misuse of
the device. The user shall be solely liable for the improper use of the device.
______________________________________________________________
Grounding installation
This appliance is classified as protection class I and must be connected to a
protective ground. Grounding reduces the risk of electric shock by providing an
escape wire for the electric current. This appliance is fitted with a power cord
that has a grounding wire and grounded plug. The plug must be plugged into
an outlet that is properly installed and grounded.
Electrical Requirement
• Make sure there is a suitable power Outlet ( 220-240V, 50Hz ) with proper
grounding to power the wine cellar.
• Avoid the use of three plug adapters or cutting off the third grounding in order
to accommodate a two plug outlet. This is a dangerous practice since it
provides no effective grounding for the wine cellar and may result in shock
hazard.

Related product manuals