❒ position the jack under the car, near the wheel
to be changed;
❒ operate the device A fig. 114 to extend the jack
until the top of the jack B fig. 115 fits correctly
into the side member C (next to the mark on
the side member);
❒ alert other passengers that the car is about to be
raised; all persons should be kept away from the
car until it has been lowered;
❒ fit handle D fig. 114 into the housing in device
A, operate the jack and raise the car until the
wheel is a few centimetres from the ground;
❒ remove the wheel cap after loosening the 3
fixing bolts and finally loosen the fourth bolt
and extract the wheel (only for versions with
wheel caps fixed by bolts);
❒ make sure the contact surfaces between
space-saver wheel and hub are clean so that the
fastening bolts will not come loose;
❒ fit the space-saver wheel by inserting the first
bolt for two threads into the hole closest to the
valve;
❒ take the wrench A fig. 113 and fully tighten the
fixing bolts;
fig. 111
L0F0099
fig. 112
L0F0183
fig. 113
L0F0179
160
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
To Next Page
