GLOVE COMPARTMENT LIGHT
To change the bulbs, proceed as follows:
❒ open the glove compartment and extract the
roof light A fig. 146;
❒ open the protection B and replace the bulb;
❒ re-close the protection B on the lens;
❒ refit the roof light A by inserting it in its correct
position firstly on one side and then pressing on
the other until it clicks into place.
REPLACING FUSES
GENERAL INFORMATION
Fuses protect the electrical system: they intervene
(blow) in the event of a fault or improper
intervention on the system.
When a device does not work, check the condition
of its protective fuse: the conductor element A
fig. 147 must be intact. If it is not, replace the
blown fuse with another with the same amperage
(same colour).
B = intact fuse;
C = fuse with damaged filament.
To replace a fuse, use the tweeters D hooked to the
fuse box lid on the left-hand side of the
dashboard.
Refer to the tables on the following pages to
identify the protective fuse.
fig. 146
L0F0065
fig. 147
L0F0005
181
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
To Next Page
