Replacing the rear window wiper blade
Proceed as follows:
❒ raise cover A fig. 163, undo nut B and remove
arm C;
❒ correctly position the new arm, fully tighten nut
B then lower cover A.
SPRAY NOZZLES
Windscreen washer
The window washer jets A fig. 164 are fixed. If
there is no jet of fluid, firstly check that there
is fluid in the reservoir (see "Checking fluid
levels" in this chapter).
Then check that the nozzle holes are not clogged;
use a needle to unblock them if necessary.
IMPORTANT In versions with a sun roof, make
sure that the sun roof is closed before operating
the window washer jets.
fig. 163
L0F0222
fig. 164
L0F0221
214
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
To Next Page
