EasyManua.ls Logo

Landa VNG8-3000 - Warning and Check Lists

Default Icon
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8.913-939.0 • LANDA VNG • Rev. 5/11
OPERATOR’S MANUAL
PRESSURE WASHER
12
INSTALLATION
CHECK LIST BEFORE STARTING:
WARNING
HAS ELECTRONIC
SPARK IGNITION. DO
NOT ATTEMPT TO
LIGHT MANUALLY.
CAUTION: If “NO” has been checked on any of the
above questions, do not operate the machine.
CAUTION: This machine is
equipped with an electronic
ignition system. Lighting of the
pilot is accomplished through
electronic spark ignition. Do not
attempt to light the appliance
manually as a burn injury or
electrical shock may result.
YES NO
Has gas supply been inspected by an
authorized contractor to meet local
codes?
Is machine protected from downdraft
and excessive wind?
Is machine shielded from moisture
or water spray?
Is the voltage correct and are the circuit
breaker and supply cord adequate
according to specifications and serial
plate notation?
Is the machine electrically grounded?
Is there ample water supply?
Have all flammable liquids or gases been
removed from installation location?
Is there adequate gas supply for the
BTU rating of the burner?
Is incoming gas supply pressure
between
6 - 14 water column inches or 1/2
PSIG?
Has the proper gas regulator been
installed for pressure and volume?
Is the machine properly vented to allow
adequate air flow?
Are the propane tanks large enough,
ac cord ing to ra t ing to pr even t
freezing?
Have gas lines been checked for gas
leaks?
Have gas lines been checked with local
codes?
Have all operators using this machine
been instructed properly & have they
read the manual?
Has the machine been installed
according to operator's manual
instructions?
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING
If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal
injury or loss of life.
A. This appliance has an electronic ignition system.
When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appli-
ance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
FOR YOUR SAFETY
“WHAT TO DO IF YOU SMELL GAS”
Do not try to light any appliance.
Do not touch any electrical switch, do not use any
phone in your building.
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to turn the gas control. Never use
tools. If the knob will not push in or turn by hand, don’t
try to repair it; call a qualified service technician. Forced
or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.

Related product manuals