EasyManua.ls Logo

Lander RAFALE-M - Flight Operations and Troubleshooting; Taking Off and Flight Procedures; Landing Procedures; Common Flight Problems and Solutions

Lander RAFALE-M
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 13 -
Flight attention
Do not fly at any place where another same-frequency model is being operated.
Taking off:
Taking off:Taking off:
Taking off:
Always take off toward the wind.
When launch RAFALE-M by hands, maximize the power (include the micro-adjuster) and run several
meters, then throw the RAFALE-M horizontally. When launch RAFALE-M on the ground, maximize
the power and let RAFALE-M accelerate in direction of the wind and keep it running straightly,
after it run more than 60 feet, then pull the elevator joy stick, and it will take off.
Flight:
Flight:Flight:
Flight:
To keep RAFALE-M flying only need 50% of the maximum power, it is a good idea to fly with power
for a while and glide for a while. In this way you can prolong the maximum flight time and
familiarize yourself with landing approaches.
Landing:
Landing:Landing:
Landing:
Before landing, switch off the power, fly along with the wind, and when RAFALE-M flies near
to the ground, then pull the elevator joystick and RAFALE-M will landing gently. With more
practice, then you could control the model easily.
Phenomenon Problem How to solve
Motor does not run
Battery is not fully charged.
The battery in the transmitter is not at full power.
The circuit in Rafale-M has been damaged due to
crash.
Charge the battery.
Install new dry cells.
Contact the distributor.
Can not fly straightly The rudder is not on the center position. Adjust the rudder on the center position.
Adjust the micro-adjuster on the transmitter
for the rudder on the suit position.
Can not climb
The battery is not fully charged.
The elevator declines downward.
Charge the battery.
Adjust the micro-adjuster on the
transmitter.
Control distance is very
near
The battery of transmitter is not at full power.
The antenna of transmitter has not been completely
pulled out
Install new dry cells.
Completely pull out the antenna of
transmitter.

Related product manuals