3. Install Lanmodo Car Tent On Car
1.Take out Lanmodo car tent from package;
2. Install the car tent base at the center roof of your vehicle, please make sure the car roof surface is clean and
smooth to put suction and ensure car tent handle with security strap is facing you;
3. Untie the gathering rope;
4. Pull the suction handle down to activate the suction, please make sure the suction is stable;
5. Trap the security strap inside the door of the vehicle;
6. Deploy the canopy by pressing “Open” button on wireless remote controller (Please stop instantly by
pressing “Open” button if the canopy is obstructed, and then operate open or close process);
7. Locate all the windproof ropes.
4. Product Specification
Motor Brush Motor
Rated Motor Power 10W
Working Currency 1A
Maximum Power 1000N.M
Battery 18650 Lithium Battery
Capacity 2200mAh
Full Charge by Car Charger 5 Hours
Full Charge by Wall Charger 3 Hours
USB Output 5 V
Structure Fiberglass & Metal
Fiberglass tensile strength 6.3 ~ 6.9 g/d
Connector Plastic
Canopy 210D Oxford cloth
Water Pressure 350Mpa
To Next Page
Loading...