Lantronix EDS1100 - Page 135

5: Commands and Levels
EDS1100/2100 Command Reference 135
clrscrn
Clears the screen.
connect string <text>
Sets the CONNECT string used in modem emulation.
<string> = connect string.
default incoming connection
Default disables incoming network connections.
default response type
Default uses text type responses.
display remote ip disable
The incoming RING has nothing following it.
display remote ip enable
The incoming RING is followed by the IP address of the caller.
echo commands disable
Does not echo modem commands.
echo commands enable
Echoes modem commands.
echo pluses disable
Does not echo the +++ characters when entering modem
command mode.
echo pluses enable
Echoes the +++ characters when entering modem command
mode.
error unknown commands disable
Returns OK on unknown AT commands.
error unknown commands enable
Returns an error upon unknown AT commands.
exit
Returns to the tunnel level.
incoming connection automatic
Automatically answer incoming network connections.
incoming connection disabled
Disable incoming network connections.
incoming connection manual
Wait for an ATA command before answering an incoming network
connection.
no connect string
Removes optional CONNECT string information for modem
emulation.
reassert
Asserts tunnel modem status with current configured values.
response type numeric
Uses numeric type responses.
response type text
Uses text type responses.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
show status
Displays tunnel modem status.
verbose response disable
Does not send Modem Response Codes.
verbose response enable
Sends Modem Response Codes out on the Serial Line.
write
Stores the current configuration in permanent memory.
modem (tunnel-modem:1) level commands
clrscrn
Clears the screen.
connect string <text>
Sets the CONNECT string used in modem emulation.
<string> = connect string.
default incoming connection
Default disables incoming network connections.
default response type
Default uses text type responses.
display remote ip disable
The incoming RING has nothing following it.
display remote ip enable
The incoming RING is followed by the IP address of the caller.
echo commands disable
Does not echo modem commands.
echo commands enable
Echoes modem commands.
echo pluses disable
Does not echo the +++ characters when entering modem
command mode.
echo pluses enable
Echoes the +++ characters when entering modem command