Lantronix EDS1100 - Page 138

5: Commands and Levels
EDS1100/2100 Command Reference 138
unchallenged.
password <text>
Sets the password required on the network side of the tunnel to
begin
a connection.
prompt disable
Inhibits any prompting for password on the network side of the
tunnel.
prompt enable
Sets up so a user on the network side of the tunnel will be
prompted for
a password.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
write
Stores the current configuration in permanent memory.
password (tunnel-accept-password:1) level commands
clrscrn
Clears the screen.
exit
Exits to the next higher level.
no password
Removes the password so connections will be accepted
unchallenged.
password <text>
Sets the password required on the network side of the tunnel to
begin
a connection.
prompt disable
Inhibits any prompting for password on the network side of the
tunnel.
prompt enable
Sets up so a user on the network side of the tunnel will be
prompted for
a password.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
write
Stores the current configuration in permanent memory.
ppp 1 (ppp:1) level commands
authentication mode chap
Sets authentication to Challenge-Handshake Authentication
Protocol (CHAP).
authentication mode ms-chap
Sets authentication to MS-CHAP version 1.
authentication mode ms-chapv2
Sets authentication to MS-CHAP version 2.
authentication mode none
Removes PPP authentication.
authentication mode pap
Sets authentication to Password Authentication Protocol (PAP).
clrscrn
Clears the screen.
default authentication mode
Removes PPP authentication.
exit
Exits to the configuration level.
line <line>
Enters the line level.
<line> = number of the line (serial port) to be configured.
local ip <ip address/cidr>
Sets the Local IP address and network mask.
Formats accepted:
192.168.1.1 (default mask)
192.168.1.1/24 (CIDR)
"192.168.1.1 255.255.255.0" (explicit mask)