Lantronix SGX 5150 - Page 355

5: Commands and Levels
SGX™ 5150 IoT Device Gateway Command Reference 355
write
Stores the current configuration in permanent memory.
syslog (config-syslog) level commands
clrscrn
Clears the screen.
default local port
Clears the syslog local port.
default remote port
Restores the default syslog remote port.
default severity log level
Restores the default to no logging.
exit
Returns to the config level.
host <text>
Sets the address of the syslog recipient. <text> = IP address or name of the host.
local port <number>
Sets the syslog local port.
no host
Removes the address of the syslog recipient.
remote port <number>
Sets the syslog remote port. <number> = number of the remote port used when making a
syslog connection.
severity log level alert
Log only Alert and more severe events.
severity log level critical
Log only Critical and more severe events.
severity log level debug
Log all events.
severity log level emer-
gency
Log only Emergency events.
severity log level error
Log only Error and more severe events.
severity log level infor-
mation
Log only Information and more severe events.
severity log level none
No logging.
severity log level notice
Log only Notice and more severe events.
severity log level warning
Log only Warning and more severe events.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI session.
show statistics
Displays the syslog statistics.
state disable
Disables syslog logging.
state enable
Enables syslog logging.
write
Stores the current configuration in permanent memory.
telnet (config-cli-telnet) level commands
authentication disable
No password required for Telnet users.
authentication enable
Challenges the Telnet user with a password.
clrscrn
Clears the screen.
default max sessions
Restores the default maximum allowed concurrent incoming Telnet sessions.
default port
Restores the default local port to the Telnet server.
exit
Exits to the CLI level.
max sessions <number>
Sets the maximum allowed concurrent incoming Telnet sessions. <number> = number of
sessions.
port <number>
Sets the local port that the Telnet server uses. <number> = local port number.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI session.
show statistics
Displays the Telnet statistics.
state disable
Disables the Telnet Server.
state enable
Enables the Telnet Server.
write
Stores the current configuration in permanent memory.
terminal 1 (config-terminal:1) level commands